6
Installation
The installation must comply with applicable federal, state, and local codes having jurisdiction at your location. Utilize only
qualified beverage equipment service technicians for installation.
A Service Company Directory may be found on our website,
http://www.fetco.com
.
Setup
1. Before placing the unit, verify that it will fit in the space intended for it, and that
the counter or table will support its’ weight.
2. When the unit is in position, use a bubble level to level it front to back and side
to side by adjusting the legs.
Water Connection
1. Water inlet is ¼ inch flare fitting.
2. Install a shut off valve near the unit to facilitate service.
3. Install a backflow prevention device, a spring loaded double check valve such
as a WATTS SD-2 or SD-3 is usually accepted by most zoning authorities.
4. If an inline water filter is used (highly recommended), it should be installed after
the water shut off valve and in a position to facilitate filter replacement.
5. Flush the water supply line and filter
before
connecting it to the unit.
6. Verify that the water line provides at least 1½ gpm (5.7lpm), and that the water
pressure is between 20-75 psig (138-517 kPa)
Cleaning & Maintenance
Daily:
1. Check the drip tray and empty if necessary.
Quarterly:
1. Inspect all fittings and hoses for leaks.
2. Inspect inside of tank for lime deposits. De-lime tank and probes if necessary.
3. (This procedure to be performed by a qualified service technician)
Notice:
1. Turn off power before any cleaning procedure, including wiping the exterior for appearance reasons.
Dry the exterior, especially the face panel, before turning on power.
WARNING:
1. Equipment is designed for commercial use only. Equipment is not for household use.
2. Do not apply any type of spray cleaner on the face panel of this equipment.
3. Never use solvent or solvent based cleaner or petroleum based polish on this equipment.
4. Dry the face of the HWD-2102 before turning on power.
5. No user serviceable parts; refer to qualified service technician for repair and adjustments.
6. Dangerous high voltage and high temperatures inside
7. WARNING-Do not plug-in this equipment or attempt to operate without all covers in place and all screws fastened
8. Unplug machine before disassembly or changing settings
Warning: Legs are to be adjusted
only to level the unit. Do not extend
them higher than necessary
!
Back panel of HWB-2102
Power
Switch
Water
Supply
Inlet
Electrical
Connection
Tank
Drain