3
CONTROL PANEL LAYOUT DIAGRAM FOR HWD_2102 HOT WATER DISPENSER
Power Lamp
(Lit when unit is energized)
Ready Lamp
-Dispense will operate when lit,
-Temperature is low when not lit
Heating Lamp
For hot water tank
(is “ON” when heater is activated)
Sensor for Function Selector
selects and activates selected option
Border of UNLOCK/DISPENSE pad will:
-after unlocking by first pressing pad
Æ
glow white when ready to unlock
glow steady red when ready to dispense
Pulsates rapidly to show a fault state
Silicone Tap for hot water dispenser
To dispense with MANUAL CONTROL
—[Press and hold
!]
1) Press UNLOCK/DISPENSE pad for 1-3 seconds to unlock and activate dispensing system
-Border of UNLOCK/DISPENSE pad will change: turning steady red signaling activation
2) Remove finger from pad
-Border of UNLOCK/DISPENSE pad will
glow steady red: ready to dispense
3) Press center of UNLOCK/DISPENSE pad to dispense. Keep finger on pad until dispense is complete.
-Dispense automatically stops when time out is complete, or if finger is removed.
Multiple dispenses are possible when the light bordering the UNLOCK/DISPENSE pad is steady and red colored
Lift finger and reactivate after portion by retouching pad for next dispense portion. Finger must be on pad to dispense.
To dispense for PORTION CONTROL
—[Touch and
Hold!]
1) Press and hold UNLOCK/DISPENSE pad for 3 seconds to unlock and activate dispensing system
-Border of UNLOCK/DISPENSE pad will change: and will rapidly strobe signaling activation
2) Remove finger from pad
-Selected portion will automatically complete
3) If needed: tap center of UNLOCK/DISPENSE pad to stop dispense. .
-Dispense automatically stops when time out is complete, or if pad is tapped again.
Æ
Dispense is unlocked and will function only when border of UNLOCK/DISPENSE pad is steady red.
The UNLOCK/DISPENSE pad rapidly flashes red if finger remains on it after dispensing and no water is dispensed.
If finger remains on the UNLOCK/DISPENSE pad more than 30 seconds while rapidly flashing red-the controls “lock out”
and READY LIGHT & HEATING LIGHT will flash rapidly to show a fault state. All controls are disabled during fault state.
To clear Fault State:
Switch machine “OFF” for about ten seconds, and then toggle back “ON” (Control Reset)
After controls initiate, hot water tank level and temperature are checked- then the “READY” light will activate.
Æ
This will take approximately 2 minutes for filled and heated unit; up to 20-30 minutes for a new and empty unit.
