2
FETCO Hot Water Dispenser HWD_2102
Contact Information
FETCO
®
Food Equipment Technologies Company
600 Rose Road
Lake Zurich
•
IL
•
60047-0429
•
USA
Internet:
www.fetco.com
Phone:
(800) 338-2699 (US & Canada)
(847) 719-3000
Fax:
(847) 719-3001
Email:
Description & Features
The following are the factory settings—and range of variables that are adjustable:
Temperature Control:
Water temperature is factory set at maximum—96°C/205°F
(Temperature is user selectable 87-96°C/189°-205°F)
Portion Control:
Delivery volume: factory set at 5 seconds=200ml/6.8oz
(Portion control is user selectable 5-41fl.oz/40-1200cc by timer adjustment)
Operating Principles
The HWD_2102 delivers precision temperature water at selected temperatures. The green “READY” lamp must be lit. Unit
will dispense water, not at selected temperature, if green “READY” lamp is not lit.
Unit is factory calibrated at the optimum dispense portion of 200ml/6.8oz).
Hot water is drawn from the faucet, the fill valve cycles on and off to replenish the hot water tank.
The dispense valve faucet is protected by a silicone bumper over the tap.
When dispensing water at a rate that exceeds the unit’s capacity to heat, the ready light will go off to show that the selected
preset temperature is not available. Always observe the “READY” lamp
When the “READY” lamp is lit – proper dispense temperature is enabled.
When heating or reheating, the green “READY” light will turn off and the “HEATING” light will display
Æ
Dispense flow rate is given for typical 45psi/0.31mPa water supply pressure.
!Differences in water supply pressure affect flow rate, and quantity of hot water dispensed!
Æ
After exceeding the maximum optimum dispense portion of 20fl.oz/600cc the water supply in the hot water tank
begins do become depleted. The “READY” lamp will turn off. Dispenser faucet does not “lockout”. This may allow less
heated water to dispense. For the highest selected dispense when “READY” lamp is lit.
Æ
When the HWD_2102 is powered on (or controller reset)- the controls check and adjust tank level and temperature.
This will take approximately 2 minutes for filled and heated unit; up to 20-30 minutes for a new and empty unit.
Operating Instructions
To Start:
Follow installation and set up procedures. If desired, set custom dispense temperature; dispense time/volume interval.
1) Open water supply valve
2) Power unit “ON” from rear power switch. Unit will fill and heat (up to 20 minutes for a new unit).
-After unit is filled and heated
3) Ready Lamp will glow green
-Unit may be operated when Ready Lamp is “off” (after initial fill).
4) White colored backlight intensity of control panel slowly pulsates during “READY” condition
Æ
the HWD_2102 should be left “ON”. The hot water tank is well insulated to control energy loss.
-The HWD_2102 is ready to dispense-
Refer to control panel layout diagram for HWD_2102 hot water dispenser on Page 3
