Festo SLG-Z Series, Operating Instructions Manual

Page: 22 / 88

SLG−Z−...
Festo SLG−Z−... 0512a English
22
Type SLG−Z−8−... SLG−Z−12−... SLG−Z−18−...
Tightening torque
Cushioning support
Fastening rail
Intermediate position module
2.9 Nm
1.2 Nm
0.76 Nm 2.9 Nm
1.2 Nm
0.76 Nm 5.9 Nm
2.9 Nm
1.2 Nm
Fig.14
S
Fasten the intermediate position module type SLG−Z−... as follows:
1. Push the sliding block into the groove (E)
of the fastening rail and screw the two
fastening screws through the intermedi
ate position module into the sliding block.
It should then still be possible to shift the
intermediate position module type
SLG−Z−... .
2. Push the slide of the pressureless linear
drive (e.g. slide unit type SLG−...) by hand
into the intermediate position.
3. Align the intermediate position module in
the direction of the stop and place it in the
toothed profile of the fastening rail (stop
possible from left and from right). The
position of the stop to the mid−position
can then be adjusted by ±0.75 mm.
The minimum permitted distance X
1
for
swivelling the stop lever and for the pneu
matic connections X
2
must be observed
here (see Fig.17).
SLG−Z−... 8−... 12−... 18−...
Minimum distance
for swivelling the
stop lever X
1
for thescrew
connection X
2
23 mm
16 mm
23 mm
16 mm
31 mm
16 mm
Fig.17
Fig.15
(E)
Fig.16
x
2
x
2
x
1