Festo SDE3 series, Operating Instructions Manual

Page: 37 / 60

SDE3−...
Festo SDE3−... 0604a English
37
5 Installation
Mechanical installation
S
Mount the SDE3−... and connect the tubing so that no condensation from the
compressed air lines can gather in the device.
SDE3−... −HQ...− −WQ...− −FQ...− ...
Fasten
ing type Hat rail Wall mounting Front panel mounting Plate fitting
Remarks Fit the adapter
plate
(e.g. 2 x M3)
1)
1)
Hang the SDE3−... onto the hat
rail/fastening plate and press
until the fastening slide clips in. Push the SDE3−...
into the recess
(70 x 22 mm) in the
front panel. Hang on
the clamping plate
and press until the
fastening slide clips
in. Tighten the
screws.
2) 3)
Through−hole
3.4mm
1)
Hole pattern see page 59.
2)
With a front panel of thickness < 2 mm remove the washers if necessary.
3)
Max. tightening torque: 0.3 Nm (clamping plate against front panel).
Fig.7