HMP−...−B−...
Festo HMP−...−B−... 0408NH English
43
Accurate adjustment of an end position:
On the stop
On the shock absorber
aG
aI
(u)
aE
(v)
bJ
1. Pressurize the compressed air port of the end position to be adjusted.
2. Remove the housing cover
2
of the linear module HMP−....
3. Loosen the locking screws
aG
by
2turns.
4. Turn the stop with a wrench at
aI
until
the desired end position is reached.
(Note maximum values (u) in accord
ance with the following table)
5. Tighten the locking screws
aG
(tightening torque see table).
3. Loosen the locking screws
aE
by
2turns.
4. Turn the shock absorber sleeve (and the
shock absorber) with a wrench at
bJ
until the desired end position is
reached (Note maximum values (v) in
accordance with the following table).
5. Tighten the locking screws
aE
(tightening torque see table).
6. Repeat the settings for the opposite end position.
7. Fasten the housing cover
2
again.
8. Exhaust the linear module type HMP−... .
Fig.31
HMP−...
16
20/25
32
Width across flats
aG
/
aE
/
aI
/
bJ
3 / 3 / 13 / 13
4 / 4 / 17 / 17
4 / 4 / 22 / 22
Maximum setting (u)
10 mm
12.5 mm
15 mm
Maximum setting (v)
10 mm
12.5 mm
15 mm
Tightening torque
aG
2.9 Nm
5.9 Nm
5.9 Nm
Tightening torque
aE
2.9 Nm
5.9 Nm
5.9 Nm
Fig.32
Summary of Contents for HMP-x-B Series
Page 55: ...HMP B Festo HMP B 0408NH 55...