Festo CPX-2AA-U-I, Electronic Manual

Page: 152 / 228

4. Analogue input module CPX−4AE−T
4−30
Festo P.BE−CPX−AX−EN en 0503b
F au l t num b e r D esc r i p ti o n F au l t t r eatment
15 M od u l e / c h anne l f ai l e d
2)
General fault, module faulty.
·
Power off/on necessary
·
If this fault occurs again: check
and, if necessary, replace the
analogue input module.
Evaluation of the analogue input
signals has stopped.
29 F au l t in p a r amet r i z in g
1) 3)
A fault has occurred in the setting of a
parameter:
wire fracture
connection design of the sensor
sensor type and temperature range.
·
Check the parametrizing
undertaken and, if necessary,
undertake the parametrizing again
with the correct parameters (valid
parameters see section 4.4.3).
The analogue input module will be
operated further with the last valid
parametrizing.
1)
The analogue input signals will, however, be processed further.
2)
Processing of the analogue input signals will be stopped. This error message will be triggered by
the field bus node.
3)
The parameters entered will be ignored, the module operates with the last valid parameters.
Tab.4/20: Error messages of the input modules part 2
No te
Please note the following when using the input modules:
If there is a short circuit, all sensor supplies of the
module will be switched off t og et h e r .
The sensor power supply will be switched on again
aut o matica lly when the short circuit is eliminated.