Festo CP-A08 Series, Manual

Page: 5 / 67

Designated use
The CP modules described in this manual have been
designed exclusively for use on a CP string, an axis
interface string or a CP branch line in conjunction with
a CP field bus node, the SPC200 Smart Positioning
Controller or the Powerbox type CP-FB-TBOX-SUBD9.
CP modules and CP cables may only be used as
follows:
– as intended for use
– in original condition
– without unauthorized modifications
– in faultless technical condition
If used in conjunction with commercially-available com-
ponents such as sensors and actuators, the specified
limit values for pressures, temperatures, electrical data,
torques etc. must be observed. Please comply also with
national and local safety laws and regulations.
All CP modules comply with protection class III.
WARNING
Use only power units which guarantee reliable
isolation of the operating voltages as per IEC 742 /
EN 60742 / VDE 0551 with at least 4 kV isolation
resistance (protected extra low voltage, PELV).
Switch power packs are permitted if they guarantee
reliable isolation in accordance with EN 60950 /
VDE 0805.
IV
CP..EA 9901b