© Ferno-Washington, Inc. 234-2117-01 May 2003
13
Ultra Care 4000
™
Using the Lift
ATTACHING A STRAP
1. Place the keyhole opening over a post on the
spreader-bar assembly and pull the tang down to
seat the post in the small end of the keyhole
(Figure 13).
2. Repeat Step 1 to attach the other end of the strap
to the opposite side of the spreader-bar.
REMOVING A STRAP
1. Grasp the pull loop with one hand, hold the
spreader bar steady with your other hand, and
pull the loop up to slide the large end of the
keyhole tang over the post (Figure 14).
2. Remove the keyhole tang from the post.
Figure 13 - Attaching a Strap
Posts on
Spreader-Bar
Keyhole Tang
Pull
Figure 14 - Removing a Strap
Pull Loop
Pull
5.6 Using the Extractor Wand
Use the supplied plastic extractor wand (Figure 15) to
help position straps around and under the body or
casket. To use the wand:
1. Detach the D-ring end of a strap from one side of
the spreader-bar and place the D-ring next to the
body or casket to be lifted.
2. Slide the wand under the body or casket until the
hook is near the D-ring and grasp the D-ring with
the hook.
3. Pull the strap under the body or casket.
4. Attach the strap to the spreader-bar post by the
keyhole tang. Never attach a strap to the lift by
the D-ring.
Figure 15 - Plastic Extractor Wand
Hook