18
Tirol Kit
© Ferno s.r.l. Rel.30092022 ENG
4. Place the connected plates in a vertical position
5. Apply 1 drop of threadlocker on the theaded end of the
two M8x50 adjustment screws.
6. Tighten them in the circled holes using the appropriate 6
mm Allen wrench until there is no more backlash between
them.
7. Position the striker plate on the bottom plate so that you
can see the adjutment screws, making sure that the recessed
hole remain on the outside.
8. Apply 1 drop of threadlocker on the theaded end of the
four M6x16 countersunk head screws
9. Using the 6mm Allen wrench slightly tighten the striker
plate onto the bottom plate screwing the four M6x16
countersunk head screws.
NOTE: Keep a clearance of some millimetres between the
striker and bottom plates.
10. Loosen the adjustment screws with the 6mm Allen
wrench so that the Tirol Kit Adapter plates are connected
but some backlash between them can still be possible.