USER’S MANUAL OF WLAN ACCESS POINT
Version: 1.1
Item
D
escription
Authentication Type
Click to select the authentication type in
Open System
,
Shared Key
or
Auto
selection.
Fragment Threshold
Set the data packet fragmentation threshold, value can be
written between 256 and 2346 bytes.
Refer to 4.10 What is Fragment Threshold?
RTS Threshold
Set the RTS Threshold, value can be written between 0
and 2347 bytes.
Refer to 4.11 What is RTS(Request To Send) Threshold?
Beacon Interval
Set the Beacon Interval, value can be written between 20
and 1024 ms.
Refer to 4.12 What is Beacon Interval?
Data Rate
Select the transmission data rate from pull-down menu.
Data rate can be auto-select, 11M, 5.5M, 2M or 1Mbps.
Preamble Type
Click to select the
Long Preamble
or
Short Preamble
support on the wireless data packet transmission.
Refer to 4.13 What is Preamble Type?
Broadcast SSID
Click to enable or disable the SSID broadcast function.
Refer to 4.14 What is SSID Broadcast?
IAPP
Click to enable or disable the IAPP function.
Refer to 4.20 What is Inter-Access Point Protocol(IAPP)?
802.11g Protection
Protect 802.11b user.
RF Output Power
To adjust transmission power level.
Turbo Mode
Click to enable/disable turbo mode.(
Only apply to
WLAN IC of Realtek
).
Apply Changes
Click the
Apply Changes
button to complete the new
configuration setting.
Reset Click
the
Reset
button to abort change and recover the
previous configuration setting.
15
3.3.5
Wireless - Security Setup
This page allows you setup the wireless security. Turn on WEP, WPA, WPA2 by
using encryption keys could prevent any unauthorized access to your wireless
network.
