USER’S MANUAL OF WLAN ACCESS POINT
Version: 1.1
2
Installation
2.1
Hardware Installation
Step 1: Place the Wireless LAN Access Point to the best optimum transmission location.
The best transmission location for your WLAN Access Point is usually at the
geographic center of your wireless network, with line of sign to all of your
mobile stations.
Step 2: Connect the WLAN Access Point to your wired network. Connect the Ethernet
LAN interface of WLAN Access Point by category 5 Ethernet cable to your
switch/ hub/ xDSL modem or cable modem. A straight-through Ethernet cable
with appropriate cable length is needed.
Step 3: Supply DC power to the WLAN Access Point. Use only the AC/DC power
adapter supplied with the WLAN Access Point; it may occur damage by using a
different type of power adapter.
The hardware installation finished.
2.2
Software Installation
¾
There are no software drivers, patches or utilities installation needed, but only the
configuration setting. Please refer to chapter 3 for software configuration.
Notice:
It will take about 55 seconds to complete the boot up sequence after
powered on the WLAN Access Point; Power LED will be active, and
after that the WLAN Activity LED will be flashing to show the WLAN
interface is enabled and working now.
5
