FENIX IMVICO
TK-41 OPERATION MANUAL
6/88
IMPORTANT NOTES ON TK41 HANDLING
In order to guarantee a long life of the printer, it is necessary to keep some
precautions on the TK41 handling. Please read carefully next lines to make a
good use of the printer.
SAFETY PRECAUTIONS
Before using the printer, please carefully read point 2- INSTALLATION.
BEWARE not to invert power supply polarity. This may irremediably damage the
printer.
Use power supply voltage within specified range. Overvoltage may irremediably
damage the printer. Voltage under the specified range may cause incorrect
operations.
Keep TK41 away from water or any other liquid.
Do not use in locations subject to high humidity or dust levels.
DO NOT put any objects into the printer. It could cause severe damage like
shortcircuits, broken thermal head or general printer failure.
DO NOT blow the TK41.
•
NEVER modify the TK41.
•
DO NOT try to repair the TK41 by yourself. If some failure is detected contact
with your usual dealer technical service.
•
Since the printer contains permanent magnets (in the motor) as well as
elctromagnets, it should not be used in areas containing excessive dirt, dust
and metallic particles.
•
Never print without paper installed or the head away from the platen, because
the life of the thermal head may be shortened.
•
Never pull the paper out (forward or backward) with the head down against
the platen.
•
Since the head heating elements and the driver IC are very delicate, avoid
touching them with any metal objects, such as tweezers or screwdrivers.
•
Since the head area and the motor surface reaches high temperatures right
after printing, never touch it with your bare hands; wait about 15 min. For it to
cool.
•
Never touch the surface of the head heating elements and the driver IC, as
dirt may stick to them, affecting the head heating elements or causing
damage by static electricity.
