EN
GL
ISH
Specifications
TYPE
PR 4826
POWER
Requirements: 100 watts
Output: 20 watts RMS into 8Ω @ 10%THD, 1kHz
INPUT IMPEDANCE
1 MΩ (Normal input 1, Bright input 1)
136 kΩ (Normal input 2, Bright input 2)
OUTPUT IMPEDANCE
8Ω (internal and external speaker jacks combined)
SPEAKER
One 12” Jensen® C-12Q (8Ω, PN 7710781000)
TUBES
One pair 6V6 (power, PN 0069673300)
Four 12AX7 (preamp, PN 0074287400)
Two 12AT7 (preamp, PN 0078799200)
One 5AR4 (rectifier, PN 0041400000)
FUSE
F2A L 250V (100V-120V models)
F1A L 250V (220V-240V models)
ACCESSORIES
Deluxe fitted cover (included, PN 7710649000)
Two-button footswitch (included, PN 7711022000)
DIMENSIONS
Width: 24.3” (61.7 cm)
Height: 16.9” (42.9 cm)
Depth: 9.3” (23.6 cm)
WEIGHT
38.2 lbs. (17.3 kg)
Product specifications subject to change without notice.
Rear Panel
K. FUSE:
Provides electrical overcurrent protection. The mains fuse
is not user accessible and should only be replaced by qualified
service personnel.
L. POWER:
Turns the amplifier on and off.
M. STANDBY:
Disables speaker output while power is on. To extend
tube life, leave switch in STANDBY position for first 60 seconds
after turning POWER (L) on. Instead of turning amp off during short
breaks, set switch to STANDBY position to further extend tube life
and to avoid tube-warmup delay when resuming play.
N. INTERNAL SPEAKER:
Jack for internal 8-ohm speaker. If connect-
ing a different speaker to this jack, it should have an impedance of
8 ohms
when this is the only jack in use
.
O. EXTERNAL SPEAKER:
Jack to allow use of multiple speakers;
wired in parallel with INTERNAL SPEAKER jack (N) and affecting
total impedance. External speaker jack does
not
function when
INTERNAL SPEAKER jack (N) is disconnected.
P. FOOTSWITCH:
Connect the included two-button footswitch
here. The footswitch
must
be connected for the amp’s tremolo
effect to function.
Q. REVERB OUTPUT/INPUT:
RCA jacks connecting output/input of
reverb pan located on the floor inside the cabinet.
For questions and troubleshooting,
contact a Fender specialist at:
1-800-856-9801 (U.S. toll free)
1-480-596-7195 (International)
SERIAL NUMBER
POWER
ON
STANDBY
ON
EXT.
SPKR.
REVERB
OUTPUT
REVERB
INPUT
FOOT
SWITCH
A product of:
FENDER MUSICAL INSTRUMENTS CORP., 311 CESSNA CIRCLE CORONA, CA 92880 U.S.A.
MODEL: ’64 CUSTOM
DELUXE REVERB
®
-AMP
F2A L
250V
FUSE
INT.
SPKR.
PARALLEL
SPEAKER
JACKS
20 WATTS
8
Ω MIN
TOTAL
INPUT POWER
100W
120V 60Hz
TYPE: PR4826
WARNING:
TO REDUCE
THE RISK OF FIRE OR ELECTRIC
SHOCK DO NOT EXPOSE
THIS
EQUIPMENT TO RAIN OR
MOISTURE
AVERTISSEMENT:
RISQUE DE CHOC ELECTRIQUE !
NE PAS OUVRIR !
フェンダー·
ミュージック(株)
WARNING:
MAINTAIN 6" CLEARANCE FOR VENTILATION.
CAUTION:
CHASSIS SURFACE HOT
ATTENTION:
SUPERFICIE DE
CHASSIS CHAUDE
ATTENTION:
UTILISER UN FUSIBLE
DE RECHANGE DE MEME TYPE ET CALIBRE
CAUTION:
TO REDUCE THE RISK OF
FIRE, REPLACE FUSE WITH SAME TYPE AND
RATING
WARNING:
FENDER AMPLIFIER SYSTEMS
ARE CAPABLE OF PRODUCING VERY HIGH
SOUND PRESSURE LEVELS WHICH MAY
CAUSE TEMPORARY OR PERMANENT
HEARING DAMAGE. USE CARE WHEN
SETTING AND ADJUSTING VOLUME LEVELS
DURING USE.
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE BACK COVER. NO USER
S E R V I C E A B L E P A R T S I N S I D E , R E F E R
SERVICING TO QUALIFIED PERSONNEL ONLY.
3
