34
116
115
114
!
!
!
!
"
#
$
%
&
$
"
#
#
"
Multi Boring Machine
FD 21 professional
Fig. 7-9: Depth stop (Vertical drilling)
Fig. 7-10: Crosscut stop (Stop extension)
7.9 Depth stop (with vertical drill)
7.10 Crosscut stop (on the stop extension)
1.
Switch off the machine.
2.
Release the clamping lever (on both sides)
3.
Loosen the thumb screws from the locking.
4.
Depth stop: is positioned to the required amount
(is read from the magnifying lens)
5.
Tighten the clamping lever (on both sides)
quick adjustment
1.
Loosen the setscrews (on both sides!).
2.
Depth stop + Lock pins:
Move to the desired position
3.
Pull both threaded pins tight (on both sides!).
4.
Fine adjustment: Correct the misadjustment with the
setting screw
The crosscut stop can be positioned freely along the
fence.
If required, the end stop can be folded back.
1.
Loosen the thumb screw.
2.
Move the cross stop to the desired position. The mea-
surement (rip capacity) is read from the magnifying
lens.
3.
Tighten the thumb screw.
Making adjustments and preparations
!
Scale / Lens
"
Crosscut stop
#
Thumb screw
$
End stop
!
Single-hand clamping lever
"
Thumb screw
#
Scale / Lens
$
Setscrew
%
Lock pins
&
Adjusting screw
Note: with vertical drill: Mortising height adjustment = 0 mm
See chapter entitled >Mortising height adjustment / Mortising depth adjustment<
