32
$
$
"
!
!
min
max
0˚
90˚
400060-163
0˚
6 Bar
1
2
90˚
=
=
3
400060-183
#
!
#
Multi Boring Machine
FD 21 professional
Adjusting the angle:
1.
Switch off the machine.
2.
Set the angle between 90° and 0° on the scale.
3.
Single-hand clamp levers tighten drill unit tilt.
Drill unit tilt:
Execute the following instructions exactly (sequence)!
1.
Prior tilting: Check switch position (Drill unit tilt)
2.
Ensure that air pressure amounting to 6 bar is present
in the machine.
3.
Loosen the clamping lever.
4.
Turn the switch on the control panel
5.
The unit tilts up to the mechanical positive stop.
6.
Clamp the clamping lever.
The position of the boring unit can be read from the tilt
scale
Warning! danger of trapping / Risk of injury!
Keep hands away from the boring unit during tilting
Beware of any possible collisions with stops and work pieces!
Prior tilting: Check switch position (see sticker)
with horizontal drill: 0° | with vertical drill: 90°
!
Clamping lever–Drill unit tilt
"
Scale
#
Switch–Drill unit tilt
$
Clamping lever
1.
Switch off the machine.
2.
Remove tools and stops from the work bench.
3.
Switch machine on.
4.
During forward movement adjust the rotary switch to
the desired feed rate
the feed rate is independent of the tool diameter, number
of tools and the material
!
Turn switch for feed rate
7.5 Setting the feed rate
7.6 Drill unit tilt
Note:
When positioning the unit for vertical mortising, use the scale value from the mortising depth scale minus 8 mm.
See chapter entitled >Mortising height adjustment / Mortising depth adjustment<
Fig. 7-4: Setting the feed rate
Fig. 7-5: Drill unit tilt
Making adjustments and preparations
