Federal FCCR-4, Installation & Operation Instructions

Page: 12 / 27

12
NOTICE: Avoid splashing or soaking any electrical components with water to
prevent electrical damage to the case.
NOTICE: Shut off light and power switches and remove all product from case. Allow
sufficient time for the unit to reach room temperature before proceeding
with cleaning.
Interior Cleaning
1.
Remove rear doors from track by lifting door upward until the bottom of the door clears the
lower door track and then outward. Remove the inner door in the same manner.
2. Remove all shelves from the case by sliding them rearward and through the door openings.
3. Unplug the shelf lights and lift one end then the other off the shelf brackets then through the door
opening.
4. Remove the shelf brackets from the shelf standards.
5. Open the tilt-out front glass.
6. Open the door for the rear storage area.
7. Clean the entire interior of the case using warm soapy water. Wipe off all soapy water with a
damp cloth and allow to dry.
NOTE: Depending on the amount of usage and spillage of foreign material, some fasteners may
have to be removed and parts disassembled to allow proper cleaning of the unit.
8. Clean all shelves, shelf brackets, and shelf light housings using warm soapy water and a brush.
Rinse thoroughly and allow to dry.
9. Clean all foreign material from inner and outer rear door tracks using warm soapy water and a
brush. Apply a light film of lubricant, such as PAM, to make the doors operate smoother.
10. Clean both sides of the doors, end glass, and interior of the front glass using any common
window cleaner.
CAUTION:
Do not use alcohol based or solvent cleaners on the front or side glass.
11. Reassemble the case in reverse order starting with step 6.
Exterior Cleaning
1. Clean the front glass using any common window cleaner.
CAUTION:
Do not use alcohol based or solvent cleaners on the front or side glass.
2.
The exterior surfaces should be wiped down using any ammoniated cleansers or warm soapy
water.