Federal FCCR-4, Installation & Operation Instructions

Page: 5 / 27

5
PRE-INSTALLATION PROCEDURES
Inspection for Shipping Damage
You are responsible for filing all freight claims with the delivering truck line. Inspect all cartons
and crates for damage as soon as they arrive. If damage is noted to shipping crates, cartons, or if
a shortage is found, note this on the bill of lading (all copies) prior to signing.
If damage is discovered when the case is uncrated, immediately call the delivering truck line and
follow up the call with a written report indicating concealed damage to your shipment. Ask for
an immediate inspection of your concealed damage item. Crating material must be retained to
show the inspector from the truck line.
INSTALLATION INSTRUCTIONS
Locating the Display Case
The case should be located where it is not subjected to the direct rays of the sun, heating ducts,
grills, radiator, or ceiling fans, nor should it be located near open doors or main door entrances.
Also, avoid locations where there are excessive air movement or air disturbances.
The condenser air inlet is located at the rear of the case. Do not block this inlet and do not locate
the air inlet near a source of heat.
Removing Case From Shipping Skid
CAUTION:
Do not push against the curved glass, ends, doors or
door frames when removing the case from the skid or moving the case. Case
damage or glass breakage could result.
Move the case as near as possible to the final location before removing it from the shipping skid.
Remove the eight (8) bolts that secure the case to the shipping skid.
Removing the Packaging Material
Remove the shipping tags that secure the doors, and tilt-out front glass. If it is necessary to remove
tape residue from plastic material, use cleaning compounds recommended in the Cleaning section of
this manual.