Federal FCCR-4, Installation & Operation Instructions

Page: 10 / 27

10
Light Switch
This switch controls the power to the lighting circuit. The switch rocker is red in the “on”
position, black in the “off” position.
High Pressure Safety Control
This is a safety device. It is nonadjustable and will shut off the compressor if system pressure
exceeds 385#psig.
Shelves
The case is furnished with three (3) tiers of glass shelves which are adjustable up and down. To
reposition the shelves:
1. Turn the shelf lights off.
2. Unplug the shelf light cord.
3. Remove the glass shelves and shelf light housing from the shelf brackets.
4. Grasp the shelf bracket and remove from existing slots in pilaster.
5. Reposition the shelf bracket to the desired slots.
6. Reinstall shelf light housing and glass shelves.
7. Plug the shelf light cord in the light socket.
Light Replacement before 11/01/21
The light fixtures use a spring loaded socket on one end. To remove a light, push the bulb toward
the spring-loaded socket until the opposite end drops out of the socket.
The bulbs are furnished with plastic safety light shields. Make certain the light shields are always
in place to safeguard against bulb breakage.
When replacing lights, use direct equivalents to the original bulbs.
Light Replacement after 11/01/21
The shelf lights are fastened to the shelf support rails with a two-way tape. To remove you will
need to peal the light off. To reinstall wipe down the shelf support rail with alcohol &apply light.
Tilt-Out Front Glass
The front glass tilts out for easy cleaning of the case interior and inner glass pane. Two cables at
the top corners hold the glass in the open position.
Doors
The doors can be removed by lifting up the door until the bottom clears the bottom track.
Clean the door track frequently for easy door operation. A very light film of lubricant, such as
PAM, will help the doors slide easily.
Placing Product into Case
Do not overhang glass shelves with product or display pans. Overhanging the shelves will block
the refrigerated air flow and could cause product loss.
Do not block the slots along the front air grill or along the display deck backs.
CAUTION:
Do not push the front glass to close it. Always hold onto the
top edge when closing the front glass.