H. Remove 12VDC from all control wires and the
RED 10GA power wire. Wait 30 seconds then re-apply
12VDC to RED 10GA power wire. Check for proper op-
eration of lightbar.
EXAMPLE
To change from the defaults to 175FPM Rotate in
slide switch position three:
•
Disconnect the RED 10GA power wire.
•
Using table 3-4 and figure 3-6, set DIP switch
P3B to ON. This sets P3 to 175FPM Rotate.
•
Apply 12VDC to the WHT/YEL and WHT/
BLK control wires.
•
Reconnect the RED 10GA power wire. The
right upper LED in Pod 4 is on.
•
Move slide switch to position 3. All 3 LEDs
in Pod 1 come on and the Smart Pods are rotating at
90FPM.
•
Remove 12VDC from the WHT/BLK control
wire. Momentarily re-apply 12VDC to the WHT/BLK
control wire. The program input moves from P2 to P3;
the Smart Pods are now rotating at 175FPM.
•
Move slide switch to off.
•
Remove 12VDC from all control wires and the
RED 10GA power wire. Wait 30 seconds then re-apply
12VDC to RED 10GA power wire.
•
Check for proper operation.
IV. TESTING.
WARNING
This product contains high output LED de-
vices. To prevent permanent eye damage,
do not stare into the light beam at close
range.
After Installation, check the entire system to be
sure the lights are flashing properly and all light system
functions are operating properly.
SAFETY MESSAGE TO OPERATORS
WARNING
People’s lives depend on your safe use of
our products. Listed below are some im-
portant safety instructions and precau-
tions you should follow:
• Although your warning system is op-
erating properly, it may not be com-
pletely effective. People may not see
or heed your warning signal. You must
recognize this fact and continue driv-
ing cautiously.
• Also, situations may occur which ob-
struct your warning signal when natu-
ral or manmade objects are between
your vehicle and others, such as: rais-
ing your hood or trunk lid. If these
situations occur, be especially careful.
• This product contains high intensity
LED devices. To prevent permanent eye
damage, DO NOT stare into the light
beam at close range.
• At the start of your shift, you should
ensure that the light is securely at-
tached and operating properly.
Failure to follow these safety precautions
may result in property damage, serious injury, or
death to you, to passengers, or to others.
RETAIN AND REFER TO THIS MESSAGE
-6-
Summary of Contents for SMART VECTOR SL
Page 12: ......
