Federal Signal Corporation Personnel Alerting System, Installation And Operation Instructions Manual

Page: 75 / 84

PRE-OPERATION CHECK-OUT AND TEST
75
UVIC Field Test Data
Customer: Project Number: Date:
Contact Person: Phone: Second Phone:
Radio Shop: Contact: Phone:
Siren Type:
S/N: Voltage:
Controller Type: Antenna: Omni Yagi
Cabinet Mounted
External Mounted
A/C Service: O.H.
U.G.
CPU Software: Program file: SMV:
Radio Information: Low Band
VHF UHF 800 Trunk 12.5 KHz 25 KHz
Radio Frequency: TX RX PL
Site:
S/N: Address: Zone:
A/C voltage: Vac Battery voltage: Charger voltage:
Battery Type:
Model: Manufacturer:
1. Press buttons “2” & “3” on the CPU control board simultaneously. This will calibrate the speakers and amplifiers.
2. Remove audio output lines from Amps 1-2 on the motherboard by pulling the connector out. This will remove the speakers from
the circuit.
3. Select and execute the “ STEADY “ signal. Take RMS readings while unit is performing this function. When done recording
readings, cancel the “STEADY” signal.
4. Replace the audio output connections to re-connect the speakers.
RMS VAC
Impedance
Ω
Sensor State
Amp 1 VAC
Amp 1
Ω
Intrusion Sensor Pass Fail
Amp 2 VAC
Amp 2
Ω
Low Battery Pass Fail
AC Power On Pass Fail
AC Power Off Pass Fail
Mic mounted in Control Cabinet: Yes
No
Debris removed from Control Cabinet: Yes
No
Antenna connectors sealed: Yes
No
(Required for outdoor antenna installations)
Tested by: Date:
Notes:
Field Test Data Sheet