22
Federal Signal
signaling.fedsig.com
Figure 32 Installing the custom duty plate
PEEL OFF LABEL LINER FOR
ADHESIVE BACKED APPLICATION
TO THE REAR HOUSING SIDE WITH
TWO MOUNTING HOLES
ATTACH TWO
MOUNTING
SCREWS
Lubricating the Threaded Joints
A silicone-based, non-hardening, chemically compatible grease may be applied if required only on the rear housing’s
three threaded inlet ports.
NOTE:
When using a silicone-based grease, use caution in not applying it to the housing gasket or other parts located on
the front housing assembly. Failure to do so may compromise the sealing integrity of the device.
Maintenance and Service
EXPLOSION HAZARD: Do not disconnect the equipment while the circuit is live or unless the area is known to be free
of ignitable concentrations.
EXPLOSION HAZARD: To prevent the ignition of hazardous atmospheres, disconnect the fixture from the supply circuit
before opening.
EXPLOSION HAZARD: Substitution of any component may impair suitability for Class I, Division 2.
Service
Technical Assistance:
Contact our Technical Support Team at +1 708-587-3587 or [email protected].
Repair Service:
A return authorization is required. Contact your Authorized Distributor or Federal Signal Customer
Support. Defective products under warranty will be repaired or replaced at Federal Signal’s discretion.
Product Returns:
Returns require authorization from Federal Signal. Contact your Authorized Distributor for more
information on our return policy or to request a return.
Replacement Parts
Contact the factory for spare parts availability and part numbers. Typical spare parts are listed below. Due to
certification, certain component parts are not available for field replacement. Units with this type of damage must be
either replaced entirely or returned to Federal Signal for service.
