6
Safety Messages
Informer-PA for Public Address Interface (Model I-IP2 Series C)
Federal Signal www.fedsig.com
• Any maintenance to the unit MUST be performed by a trained electrician in accordance with
NEC Guidelines and local codes or a Federal Signal certified Service Provider.
• Never alter the unit in any manner.
• The nameplate should NOT be obscured, as it contains cautionary and/or other information of
importance to maintenance personnel.
• After installation and completion of initial system test, provide a copy of these instructions to all
personnel responsible for operation, periodic testing, and maintenance of the equipment.
• File these instructions in a safe place and refer to them when maintaining and/or reinstalling
the device.
Failure to follow all safety precautions and instructions may result in property damage, serious
injury, or death.
Installation and Service
• After installation or service, test the system to confirm that it is operating properly. Test the sys-
tem regularly to confirm that it will be operational in an emergency.
• If future service and operating personnel do not have these instructions to refer to, the system
may not provide the intended audible warning, and service personnel may be exposed to death,
permanent hearing loss, or other bodily injury. File these instructions in a safe place and refer to
them periodically. Give a copy of these instructions to new recruits and trainees. Also give a copy
to anyone who is going to service or repair the Informer.
• To reduce the risk of electric shock, do not perform any servicing other than what is contained
in the operating instructions unless you are qualified to do so. Refer all servicing to qualified
service personnel. Always test the Informer before using after repairs have been made.
Ethernet Wiring
• Unless shielded or run in conduit, Ethernet wiring must be at least six feet from bare power
wiring or lightning rods and associated wires, and at least six inches from other wire (for
example, antenna wires, doorbell wires, wires from transformers to neon signs), steam or hot
water pipes, and heating ducts.
• Do not place Ethernet wiring or connections in any conduit, outlet or junction box containing
high voltage electrical wiring.
Symbol Definition
_A _V
Indicates to reduce the risk of fire, replace fuse as marked.
Pay careful attention to the notice located on the equipment.
Read and understand the information contained in this manual before attempting to install or
service the Informer.
