9
Specifications
Description, Specifications, Installation, and Operation Manual
Federal Signal
www.fedsig.com
Specifications
Table 3 Specifications
Operating Voltages
9-15 Vdc
108-128 Vac, 60 Hz with wall transformer
Operating Current
(from wall transformer for I-IP2)
Standby (at 12 Vdc) ≤ 400 mA
Signaling (at 12 Vdc) < 650 mA
Operating with PoE,
IEEE 802.3af, 48V input
(for each Informer-PA device)
PoE: 48 Vdc (42 to 57 Vdc), IEEE 802.3af
Standby (at 48 Vdc) < 200 mA
Signaling (at 48 Vdc) < 300 mA
Audio Data
8000 samples/sec, μLaw compression
Audio Data Playback Storage
17 hours and 4,000 messages with 2 GB microSD card
Audio Frequency response
300-3000 Hz, +1 to -3 dB per octave
Warning Siren Audio
Seven factory-installed siren tones: wail, alternate wail,
pulsed wail, steady, alternate steady, pulsed steady, and
Westminster chime (auxiliary)
Serial Port
RS232C, N, 8, 1 Baud rate configurable
Ethernet Port
IEEE 802.3, 10 BASE-T connection
Operating temp range
-22°F to +140°F (-30°C to + 60°C)
Humidity range
0-95%, non-condensing
Size (H x W x L)
1.7 x 14.0 x 6.1 inches (43.18 x 355.6 x 154.94 mm)
Weight
2.5 lb (1.1 kg)
Shipping Weight
4 lb (1.8 kg)
Table 4 Compliance
Electromagnetic
Interference
Complies with FCC Title 47, Part 15
FCC Part 15
Class B
Radio Frequency Interference (RFI) (FCC 15.105)
The Informer-PA was tested and found to comply with the limits for
Class B digital devices pursuant to Part 15 Subpart B of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential environment. This equipment
generates, uses, and can radiate radio frequency energy, and if not
installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on.
Try to correct the interference by one or more of the following measures:
• Increase the separation between the equipment and the receiver.
• Connect the equipment to a different circuit than the receiver that it
is connected to.
Electrical Code
Compliance
Complies with UL 60065 and CAN/CSA Std. C22.2 No. 60065
