MSS
TM
Series
© Copyright 2022 Fluid Equipment Development Company | www.fedco-usa.com
-
40
-
Figure 83 - Lifting Unit From Mounting Position
11. Install and apply tension to approved lifting
straps as described in the
Lifting and Han-
dling
section of the
MSS Installation Manual
.
12.
Remove the shell bolts connecting to the
shell support brackets and disconnect the
drain line from the inlet.
13. Using proper lifting methods safely lift unit
from base and place on flat surface in the
vertical position.
Figure 82 - Disconnecting Drain Line
8.
Disconnect the bearing drain line from the
throttle nipple.
9. Remove the throttle nipple from the dis-
charge housing.
10. Remove the throttle nipple O-ring from the
discharge housing.
Pump Overhaul Continued
7. Install the alignment pins to prevent damage
to mechanical seal and carefully slide pump
30.5 cm (12 inches) away from motor.
NOTES:
Make sure to support inlet end of the
pump on support bracket(s).
Figure 81 - Separating Pump From Motor
