Page 35 of 35
Rev. 1.03
Problem
Cause
Solution
SYSTEM FAULT
A problem with the micro-controller.
To contact the installer of the control panel.
A problem on the zone line.
To check if there are short circuit or open circuit
along the zone line.
The end of line resistor missing.
To check if there is the end of line resistor at the end
of zone line.
ZONE FAULT
Zone line loss of balance.
To check the equivalent resistor of the zone line. It
must have a value near at the end of line resistor.
A problem on a output siren.
To check if there are short circuit or open circuit
along the siren line.
The end of line resistor missing.
To check if there is the end of line resistor at the end
of siren line.
SIREN FAULT
Siren line loss of balance.
To check the equivalent resistor of the siren line. It
must have a value near at the end of line resistor.
Fault on 230Vac / fuse.
To check the connections, the fuse, the value of the
230Vac input voltage.
POWER FAULT
Fault battery / fuse.
To check the connections, the fuse, the value of the
battery voltage.
24Vdc aux fault
24Vdc aux fault / fuse.
To check the fuse and the 24Vdc aux output voltage.
If the control panel programming does not correspond to that the user has made, it is possible
that there is been an error during the programming. To restore the control panel at the default
(§4.1).
PART 13
HOW TO SOLVE THE PROBLEMS
