FBII XL-1S, Hookup And Installation Instructions

Page: 52 / 71

Section 9 - Data Entry via LED & LCD Keypads
9–3
NOTE: THE # BUTTON MUST BE PRESSED AFTER THE ENTRY OF
the DESIRED DIGIT. THE SYSTEM WILL NOT PROGRAM THE DIGIT
UNTIL THE POUND (#) BUTTON IS PRESSED, THEREFORE IF A
MISTAKE IS MADE IT CAN BE CHANGED.
Numeric entries 0-9 can be performed by pressing the respective
keypad button. Entries of A-F require 2 keystrokes as follows
Press the CODE button followed by 1-6 for values A-F.
VALUE KEYSTROKES VALUE KEYSTROKES
A CODE 1 D CODE 4
B CODE 2 E CODE 5
C CODE 3 F CODE 6
Example: Enter an A = Press CODE followed by 1.
Exit System
Program Mode
After all programming has been completed, PRESS THE STAY BUTTON
TO EXIT THE SYSTEM PROGRAM MODE. All the LEDs will turn ON
for approximately 10 seconds, before the system returns to normal daily
operation.
Question
Acknowledgment The keypad will beep between keystrokes. In addition, a beep will be
generated confirming advancement between question numbers.
Four beeps will be generated if an invalid input is entered. Upon entry of
invalid input you are positioned at the same question number and location
as prior to the input error.
Summary of System Programming
TO ENTER PROGRAMMING
[CODE] [*] [4 digit Installer Code] [1]
TO SKIP TO A QUESTION
[*] {2 digit Question Number]
TO MOVE WITHIN A QUESTION
Press the [#] until the desired location is
reached.
TO ENTER DATA
[single digit: 0 - 9, A - F] [#]
HEXADECIMAL ENTRIES
A = [CODE] [1] D = [CODE] [4]
B = [CODE] [2] E = [CODE] [5]
C = [CODE] [3] F = [CODE] [6]
TO EXIT PROGRAMMING:
Press the [STAY].