8–1
S E C T I O N 8
System Programming
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
General
The system can be programmed in any one of the following methods:
•
Directly through keypad (XK-104 or 6805)
•
EZ-MATE PC DOWNLOADER model 7700 remotely
NOTE: The EZ-Mate downloader has not been tested for UL applications.
This manual describes system programming via the keypad. The other programming devices
include documentation describing their programming procedures.
Keypad programming is accomplished by understanding and completing the
PROGRAMMING SHEET located in the back of this manual.
There are 20 total programming questions numbered 00-19.
Within each question there are several locations labeled L1, L2, etc. for data entry.
The system is shipped from the factory with SPECIFIC DEFAULT VALUES that were
selected for a typical installation. If the default values are suitable for your installation then
programming can be simplified. The default values are listed with each programming
question and in the SYSTEM DEFAULT section of this manual.
Programming Questions
This portion of the manual defines the programming questions along with the values
expected for each question. BEFORE USING THE PROGRAMMING SHEET, FILL THE
SYSTEM PLANNING WORKSHEETS AT THE END OF THIS MANUAL. Then,
Complete the Programming sheet and then enter the data through the keypad as
explained in the section titled Data Entry Through the Keypad. DO NOT ATTEMPT
TO ENTER DATA BEFORE COMPLETELY FILLING OUT PROGRAM SHEET.
QUESTION 01
PRIMARY TELEPHONE NUMBER
DEFAULT = 234AAAAAAAAA
Enter the telephone number (including area code and/or dialing prefix IF NECESSARY) of
the primary central station receiver in L1 - L12. Enter the valid digits from the table below.
Digit
FUNCTION
COMMENTS
0-9
0-9
A
Signifies end of the phone number
Enter after last digit of phone number
B
Asterisk (
✴
)
Enter whenever the asterisk is used
C
3 Second pause
Provides delay to wait for dial tone
D
Pound (#)
Enter whenever the pound is used
E
✴
70C (Touch-tone)
✴
1170C (Rotary)
Enter to disable Call Waiting
F
800
Enter whenever the "800" prefix is needed
REPORTING ROUTE:
The system will report all signals to the primary receiver phone number. The panel will
alternate between the primary and secondary receivers (if the second phone number is
programmed) for a maximum of 8 attempts each until the signal has been acknowledged.
Summary of Contents for XL-1S
