English | Original instructions
30
To connect the DRIVEPACK, proceed as described below.
1. Remove the cover of the USB socket on the DRIVEPACK.
Do not use sharp-edged tools or similar to remove the cover as this could
damage the DRIVEPACK or the USB socket. Instead, lift the cover with your
fingers or a plastic lever.
2. Insert one USB plug into the USB socket of the DRIVEPACK and the other USB
plug into the USB port of your computer.
3. Follow the descriptions for performing the firmware update on the FAZUA
homepage.
After successfully carrying out the firmware update:
4. Disconnect the DRIVEPACK from your computer by pulling the USB plug out of
the USB socket of the DRIVEPACK. Always hold the USB plug, not the cable, to
avoid damage.
5. Then close the USB socket of the DRIVEPACK again using the cover.
IMPORTANT:
Always make sure that the USB socket on the DRIVEPACK is
securely closed with the cover to avoid dirt getting into the USB socket or the
electronics of the DRIVEPACK and damaging them.
7.2 Cleaning and maintaining components
CAUTION
Risk of injury!
If the drive system is started up while you are working on it, you may
get your fingers caught or otherwise injure yourself.
►
Remove the DRIVEPACK from the e-bike when cleaning the e-bike
or the components of the drive system.
NOTICE
Danger of damage!
Improper cleaning can damage the drive system or individual compo-
nents.
►
Never immerse the components of the drive system in water or
other liquids for cleaning.
►
Do not use any aggressive cleaning agents when cleaning.
►
Do not use any sharp, angular or metallic objects for cleaning.
