English | Original instructions
20
4.1.2 Inserting the DRIVEPACK into the e-bike
More detailed information can be found
→
in chapter 16.1 “Inserting the DRIVEPACK into the
1. Position the DRIVEPACK with the interface for the BOTTOM BRACKET onto the
corresponding interface on the BOTTOM BRACKET.
2. Swing the upper end of the DRIVEPACK into the downtube of the e-bike.
The DRIVEPACK is automatically locked in place when the two interfaces on the
DRIVEPACK and BOTTOM BRACKET are correctly interlocked and the DRIVEPACK
is completely swivelled into the corresponding holder on the downtube.
B
A
B
A
3. Check the DRIVEPACK is securely in position.
If the DRIVEPACK does not lock, repeat the procedure.
Do not use the drive system if the DRIVEPACK cannot be locked to the e-bike.
4.1.3 Removing the DRIVEPACK from the e-bike
More detailed information can be found
→
in chapter 16.2 “Removing the DRIVEPACK from the
1. Secure the DRIVEPACK with one hand.
2. Move the locking lever upwards as far as possible to release the DRIVEPACK
from the lock.
3. Hold the locking lever in the open position and at the same time carefully lower
the DRIVEPACK.
4. Then move the locking lever back to the closed position and remove the
DRIVEPACK from the interface on the BOTTOM BRACKET.