Fayat BOMAG BW 213 D-4, Operating Instructions Manual

Page: 83 / 178

5.17 Printing measuring data after completing compaction
only BTM prof
Measuring data can be printed after completion of any
pass.
Always check the paper provision before starting work.
Change the paper roll if a red stripe appears on the
paper.
At the end of the measurement press push button F7
"PRINT" Ä Fig. 98.
short actuation Line diagram
long actuation ≥5 sec. Bar chart
Control field F7 goes out and the measuring value printer starts to
print out measuring data.
After the printing process has finished any amount of
diagrams can be printed out by pressing the same
button F7 (PRINT).
If no further printouts of this track are needed, press the
button F8 “DELETE” Ä Fig. 99 when the red control lamp F6
“FINISHED” lights up.
The red control field F6 “FINISHED” goes out and the green control
field F5 “CONTINUE” lights up.
BTM plus/prof is ready to compact the next track.
Fig. 98
Fig. 99
Operation
BW 213 D-4 83