FAURA NFC260 AQUA, Owner'S Manual

Page: 121 / 134

14
Maintenance Table
During maintenance, refer to “Preparation before Operation “for disassembly and installation of each part.
Front panel
Filter
Filter subassembly
Activated carbon lter
When it is dirty
Clean it
Once for every two weeks
Remove dust and
wash it with water.
The unit has operated for
accumulated 2000 hours.
Replace it
When it is dirty
Cleaner It can’t be
washed with water.
●
Clean the dirt with
wet cloth.
●
If it is very dirty,
clean it with cloth
which had been
dipped in neutral
detergent.
●
Don’t use hard
brush (which may
cause damage).
●
Use cleaner to
remove dust and
then remove lter to
wash it.
●
When it is very
dirty, use soft brush
or neutral detergent
to wash it. Please
dry it in air after
complete cleaning.
●
Cleaner or water
can’t be used for
cleaning (otherwise
performance of lter
may decrease).
●
Remove active carbon
lter and use cleaner
to remove dust.
●
When there is odor,
spray water on the
surface and then dry it
in air (for about 1 day).
●
it can’t be washed with
water (otherwise, lter
for removing odor will
be deformed).
Refer to page 19 for
replacement method.
Requirement
●
Wipe the detergent after cleaning.
●
Don’t use water which exceeds 50
℃
.
●
Don’t dry it in the place where there is direct
sunlight.
●
Don’t use dryer to dry it.
●
Don’t dry it by re otherwise deformation
will be incurred.
About Safety Switch
●
When removing front panel, don’t scratch
the surface and damage the bulging of
inner side, in which there is safety switch.
When opening front panel, cut-off power
supply. Once it is damaged, the unit can’t
operate any more.
●
Don’t touch the hole on the bottom of the unit
(otherwise electric shock may be incurred).
Warning
Warning
Before lling water, cleaning product or maintenance, the
appliance must be disconnected from the supply mains or
unplug the power supply.
Inner side of
front panel
Don’t damage it.
Hole in the bottom