Faulhaber MC 5004, Technical Manual, Page: 21 / 66

6th edition, 22.05.2023 7000.05060, 6th edition, 22.05.2023 7000.05060
Installation
21
4 Installation
Only trained experts and instructed persons with knowledge of the following fields may
install and commission the Motion Controller:
 Automation technology
 Standards and regulations (such as the EMC Directive)
 Low Voltage Directive
 Machinery Directive
 VDE regulations (DIN VDE 0100)
 Accident prevention regulations
This description must be carefully read and observed before commissioning.
Also comply with the supplementary instructions for installation (see chap. 2.3, p. 10).
4.1 Mounting
4.1.1 Mounting instructions
CAUTION!
!
The Motion Controller can become very hot during operation.
 Place a guard against contact and warning notice in the immediate proximity of the
controller(see chap. 2.2.3, p. 10).
DANGER!
!
Incorrect handling and installation can cause the Motion Controller to perform uncon -
trolled movements.
A damaged Motion Controller can unexpectedly start, stop or jam. Depending on the use of
the Motion Controller, this can lead to severe or fatal injury.
 Observe the safety information in the chap. 2.2.1, p. 9.
 Use suitable fastening material (see the following chapter).
Visual inspection
 After unpacking the Motion Controller, perform and document a visual inspection:
 Motion Controller is undamaged?
 Sticker with serial number is present?
 Pin contacts in the connectors are OK (not oxidized, not bent)?
DANGER!
!
The function of the Motion Controller is not ensured if the visual inspection criteria are not
satisfied.
If the function is not ensured, the drive may start unexpectedly. Depending on the use of the
Motion Controller, this can lead to severe or fatal injury.
 Do not start up the Motion Controller.