CPC1001
C P C 1 0 0 1 U s e r M a n u a l
27
© 2 0 2 1 F a s t w e l V e r . 0 0 1
Table 2.1
– Recommended components for CPC1001 installation to the carrier-board
Stack height,
mm
Connector
(Foxconn)
Standoffs
(Würth Elektronik)
Note
1.5
AS0B826-S43*
9774015151
If you need to use components with a stack height of
less than 2.7 mm on the carrier board, you may need a
recess for the CPC1001 connector of the Molex type
50003340200 (used for technological purposes at
manufacturer facilities), see Fig. 2.2
2.7
AS0B826-S55*
9774027151
5.0
AS0B826-S78*
9774050151
Attention!
Immediately prior to installing the CPC1001-01 module on the carrier board, remove the
shipping
screws and fasteners (see Fig. 2.1):
- Countersunk screw M2.5
х10 - 4 pcs.
- Nut M2.5 - 4 pcs.
- Washer - 4 pcs.
Fig. 2.1
– Removal of the shipping screws on CPC1001-01
Installing CPC1001 on a carrier board is allowed only when the power is off. Failure to
comply with the above requirements may result in damages to the CPC1001 module
and the carrier board.
The SMARC connector of the CPC1001 module should be carefully inserted into the mating
connector of the carrier board (if necessary, pre-install the heatsink and the fan on CPC1001
(subparagraph 2.4)).
