Fast UT3P25, Owner'S Manual

Page: 94 / 104

SERVICE
SERVICE Utility Sprayer 25' / 30' / 40' / 45' Page 94
Spray Wand Service
Hose Replacement
Replace the hose if it is cut, worn, or
damaged.
1. Close the tank valve, agitation valve,
and spray wand valve.
2. Disconnect the hose from the reel.
a. Loosen the clamp at the spray
wand.
b. Remove the hose from its
fitting.
c. Remove the clamp from the
old hose.
3. Place the end of the hose in a pail to
allow fluid to drain.
4. Remove the hose from the hose reel.
a. Loosen the clamp from the
fitting by the hose reel handle.
b. Slide the hose off its fitting.
c. Remove the clamp.
d. Loosen the support clamp
and slide the hose through.
e. Unwind the hose from its reel.
5. Install the new hose.
a. Start the hose from the front
on the topside of the hose
reel.
b. Insert the hose through the
hole in the hose reel.
c. Slide the support clamp and
end clamp onto the hose.
d. Slide the hose onto the reel
fitting.
e. Tighten clamp.
f. Tighten fitting.
g. Install the hose support
clamp.
h. Wind up the hose leaving
enough to reach the spray
wand.
i. Slide the clamp onto the
hose.
j. Slide the hose onto the spray
wand fitting.
k. Tighten clamp.
l. Turn on the spray wand and
check for leaks.
m. Tighten clamps if needed to
stop leaks.