FOAM MARKER
FOAM MARKER
Utility Sprayer 25' / 30' / 40' / 45'
Page 80
Filling the Foam Tank
1.
BE SURE THE POWER UNIT IS
TURNED OFF. Remove the cap from
the top of the foam tank.
2.
Starting with a small amount of water
(2 gallons), mix the foam concentrate
according to its label’s directions.
a.
If
considerably
more
concentrate is needed above
the manufacturer’s suggested
ratio (usually 2-5 ounces per
gallon) to produce good foam,
use of a softener or soft water
may be required.
b.
If the foam is too stiff (dry), it
may surge out at irregular
intervals.
Under
this
condition, water should be
added until the foam
becomes softer.
3.
To ensure proper mixing of foam
concentrate and water, you may find
it necessary to partially fill the foam
tank, add the foam concentrate, then
completely fill the foam tank.
4.
Replace the cap at the top of the
foam tank.
Flow Control Valve & Tubing
Connections
The flow control valve regulates the amount
of foam solution flowing to the foam-heads.
To increase liquid flow, turn the adjusting
knob counterclockwise. This valve has been
factory preset at 1/2 a turn open. This setting
provides for a moderate foam output.
Summary of Contents for UT3P25
