Farmtrac FT 6050 CROSS, Operator'S Manual

Page: 75 / 88

22
*NOTE : In cold climate countries, maintenance free batteries with at-least 700 cold cranking Amps. are
recommended.
Operation 47 - Tractor Storage
Before storing the tractor for an extended period, the following precautions should be taken.
Clean the tractor.
Ÿ
Drain the engine, transmission and rear axle and refill with fresh oil.
Ÿ
Drain the fuel tank and pour approximately 6 Liters of special calibrating fuel into the tank. Run the
engine for at least 10 minutes to ensure complete distribution of the calibrating fuel throughout injection
system. See the next item before running the engine. Check the radiator coolant level. If the coolant is within
200 hours of the next change, renew the coolant. See Operation 48, as appropriate. Run the engine for one
hour to disperse the inhibitor throughout the cooling system.
Ÿ
Lubricate all grease fittings
Ÿ
Raise the lift linkage hydraulically and support the lift arms in the fully raised position.
Ÿ
Lightly coat all exposed hydraulic piston rods with petroleum jelly, e.g., power steering cylinder
rams, spool valves, etc.
Ÿ
Remove the battery and store in a warm, dry atmosphere. Recharge periodically.
Ÿ
Raise the tractor and place supports under the axles to take the weight off the tires.
Ÿ
Block the clutch pedal in the fully depressed position.
Ÿ
Cover the exhaust pipe opening.
Operation 48 - Preparing the Tractor for Use after Storage
Ÿ
Inflate the tires to the correct pressure.
Ÿ
Refill the fuel tank.
Ÿ
Check the radiator coolant level.
Ÿ
Check all oil levels.
Ÿ
Install a fully charged battery.
Ÿ
Remove the exhaust pipe covering.
Ÿ
Start the engine and check that all instruments and controls are functioning correctly.
Ÿ
Drive the tractor without a load to ensure that it is operating satisfactorily.
LUBRICATION AND MAINTENANCE CHART