Farmtrac FT 6050 CROSS, Operator'S Manual

Page: 40 / 88

15
Lower the implement into work using the Draft control Lever. Push the Lever forward to increase the draft
loading. Pull rearwards to reduce the draft loading. In most circumstances, forward movement of the Draft
Control Lever will increase implement depth and rearward movement will reduce the depth.
Once set, tractor hydraulic system will automatically adjust the implement depth to maintain an even pull on
the tractor and so reduce wheel slip to a minimum.
When lowering the implement into work push the Draft Control Lever down to the bottom of the quadrant to
ensure positive engagement of the implement in the ground then immediately raise the Draft Control Lever
until the required implement depth is achieved.
When the required implement working depth has been established, set the adjustable stop adjacent to the
Draft Control Lever to locate the position for repeated use. The Draft Control Lever may be eased sideways
to bypass the adjustable stop, if required.
Position Control Operation
Set the required implement height/depth using the Position Control Lever, Figure 6.
Pull the Lever Back to raise the implement height/depth using the Position Control Lever. Pull the lever back
to raise the implement, push forward to lower. Implement height/depth is relative to the position of the Lever
in the quadrant.
When the required implement working height/depth has been established, set the adjustable stop adjacent
to the Position Control Lever to locate the position for repeated use. The Lever may be eased sideways when
it is required to by pass the adjustable stop.
The adjustable stop is reversible after loosening the central clamp screw so that it may also be used when
operating in Draft Control.
IMPORTANT : When transporting equipment on the three-point linkage set the adjustable stop to maintain
the Position Control Lever in the raised position. This will prevent accidental movement of the lever which
could result in attached equipment lowering and becoming damaged or damaging the road surface.
Automatic Draft and Depth System (Blending)
Position Control may be used together with the Draft Control as follows: