TRANSMISSION
The transmission is of the constant mesh type and has eight forward and eight reverse speed ratios.
WARNING :
A safety switch prevent operation of the starting motor unless the right-hand lever is
in the neutral (N) position.
NOTE :
Always press the clutch pedal fully before changing main, shuttle (F-R), range (H-L) gear
levers and release after the gear has been selected.
The gearshift levers protrude from the center of the transmission, Adjacent to Driver Seat.
Refer figure 4.
The left-hand shuttle lever (C) is used to select forward or reverse gear ratio. The right -hand main
gearshift lever (A) is used to select any one of four gear ratio. The left-hand range lever (B) is used to
select the high (H) or low (L) range which has the effect of doubling the number of available gear ratios.
Stop the tractor and fully depress the clutch before moving either of the gear levers. See Figure 4 for
the gear shift positions.
IMPORTANT :
When towing the tractor, it is essential that the transmission main (right-hand) lever is
kept in the neutral (N) position. Noncompliance may result in damage to transmission components.
RUNNING IN-PROCEDURE
Your new tractor will provide long and dependable service if given proper care during the first 50 hours
running-in- period and if serviced at the recommended intervals.
Avoid prolonged operation at either high or low engine speeds without a load on the engine.
Avoid overloading the engine. Operating in too high a gear under heavy load may cause excessive engine
overloading. Overloading occurs when the engine will not respond to a throttle increase.
10
A. Main Shift Lever
B. Range Lever
C. Shutter Lever
4. TRANSMISSION LEVERS
SECTION A
!
!
1. Side Shift Transmission
The transmission levers are at the side of the gear box. High & Low range can be
selected by shifting the lever (B) in backward & forward direction respectively. The both transmission gear
levers (A)&(B) operates in the pattern as shown in figure. Shuttle lever(C) is used to reverse the current speed.
all
4. Gear Shift Lever Positions
H = High Range ( )
L = Low Range ( )
N = Neutral
R = Reverse
F = Forward
Summary of Contents for FT 6050 CROSS
