11
Operation 19- Engine Oil and Filter
(Only after
first 50 hrs)
Change Engine oil & oil filter after first 50 hrs of run of
the engine.
EVERY 300 HOURS carry out the preceding
checks plus the following:
The following text depicts the normal 300 hours
engine oil and filter change period. However, engines
operating in temperatures below – 12°C (10°F) or in
arduous conditions should have the oil changed every
150 hours of operation. (the oil filter need only be
changed at the normal 300 hours service interval).
In some territories, locally available diesel may have a
high sulphur content, in which case the oil change
period should be adjusted, as follows:
*
Diesel fuel sulphur content below 0.5% -
normal oil change period applies.
*
Diesel fuel sulphur content between 0.5 and
1.0%
-
Reduce oil change period to half of the
normal.
*
Diesel fuel sulphur content between 1.0 and
1.3%
-
Reduce oil change period to one quarter of
the normal.
The use of diesel fuel with sulphur content above
1.3% is not recommended.
Operation 20 and 21 - Engine Oil and Filter
18. Engine (Left Hand Side)
1. Oil Filter 2. Drain Plug
1
2
LUBRICATION AND MAINTENANCE CHART
19. Engine (Top Side)
1. Filler Plug
Clean the area around the filter. Smear clean engine oil
around the rubber seal of a new filter and install on the
tractor. Screw up until the faces just meet, then tighten
a further ¾ of a turn. Do not over tighten.
Replace the drain plug, remove the filler plug, Figure
18 & 19, and refill the engine with clean oil. Replace the
filler plug.
Run the engine for a minute or so, to circulate the oil
and then stop the engine. Wait for a short period to
allow the oil to drain back to sump then check the oil
level by means of the dipstick.
Add clean oil, as necessary, until the oil reaches the
upper mark on the dipstick.
See Section C for correct oil grade.
Operation 22-Transmission/Rear Axle Oil
Level
Pullout the dipstick (as shown figure 20) and wipe it
with a clean cloth. Replace the dipstick, pushing it fully
home and check that the oil reaches the upper mark on
the dipstick when it is removed again from the
transmission aperture.
22. Transmission / Rear Axle oil level
1. Dipstick
1
1
Summary of Contents for FT 6050 CROSS
