88
Revision date: 01.27.20
6
Install Pump
INSTALL PUMP
1
3
4
2
1. Set pump in the reservoir.
Measure from pump fitting to
bulkhead fitting. Unwrap power
cord.
NOTE:
Pump fitting and o-ring
are included with the pump.
Install these before next step.
2. Cut a tube to the length
measured in Step 1.
3. Take the tube and check the fit
by sliding it onto the pump and
bulkhead.
Cut length if needed to ensure
that hose is not too long. Pump
must rest on bottom of reservoir.
4. Pull lid into place on reservoir
and center reservoir under the
frame and tray. Reach through
port hole and slide end of power
cord up through one hole in
reservoir lid.
6
5
7
8
5. Pull cord through hole and place
it on top of the lid away from the
port hole.
6. Take the pump hose from Step
2 and slide end though the hole
where the power cord is.
7. Reach through the port hole and
slide a 111698 ratchet clamp onto
the end of the tube.
8. Slide tube onto the pump fitting.
Ensure tube is seated tightly on
the pump fitting.
