9
Revision date: 01.27.20
6
Install Pump
INSTALL PUMP—continued
9. Using a large pliers, gently
squeeze the clamp to secure the
connection. Clamp will click when
tightened.
Do not overtighten.
10. Slide another ratchet clamp onto
the pump tube.
11. Connect the tube to the bulkhead
fitting of the tray. Seat tightly on
the fitting.
12. Squeeze clamp to secure
connection.
13. Measure distance between
reservoir lid and remaining
bulkhead fitting. Add a few inches
to measurement so tube extends
through lid when attached to
fitting. Tube can be trimmed later
if too long.
Tube should remain above
nutrient level.
14. Slide a ratchet clamp onto the
tube and slide drain tube through
the hole.
15. Connect tube to the remaining
bulkhead fitting and secure as
previously described.
16. Check all fittings and clamps to
ensure they are secure.
17. System is ready to use. Add
water to cover pump and activate
pump. Check fittings for leaks.
18. Turn pump off to check
for proper drainage of the
propagation tray.
9
10
11
12
13
14
15
16
TIMER REQUIRED – ADDITIONAL PURCHASE
This system requires a timer to control the water pump and to set watering cycles.
Timer is not included and requires an additional purchase. If you do not have a timer
for your system, contact your sales representative for additional information.
