Manual
EXCELENT Premium 6; 8
15
│
52
4.
Connect the electronics according to Chapter 3.3 (12V, 40A). When the system loads on the display, press
the button for lowering/lifting the machine so that it is green, Picture 7, and lift the machine into the
transport position by the hydraulic lever in the tractor. (Attention: the rolls of the side frames will tip out
to the sides during lifting, see Picture 8).
Picture 7 – turning on lifting/lowering of the machine
Picture 8 – Tipping out the side rolls
5.
When the machine is in the transport position, secure the ball valve of the axle.
Picture 9 – Securing the axle
6.
Then tip the rolls of the side frames back into the transport position by the hydraulic lever (folding back
into the machine).
7.
Subsequently, you can remove the machine from the semi-trailer with increased caution and lay it by. Push
the machine on flat land, lift it on the axle and lean it against the side leg. Secure the wheels of the axle
against movement.
3.5.
UNFOLDING AND FOLDING MACHINE
When executing any of the hydraulic movements, slow down the moving parts of the machine before position
stop by choking a relevant valve on the tractor control!
The hydraulics of the machine must be connected to a push-pull hydraulic circuit.
The operator must ensure that there are no people or animals within the reach of the side frames during
their unfolding or folding (i.e. in the place of their position stop) and that no one puts their fingers or other
body parts into the area of the joints.
Execute unfolding or folding on flat and solid surfaces or crosswise to a slope.
Unfold or fold the machine only when it is lifted on the axle.
Remove any soil stuck on the folding places as it may disturb the function and cause damage to the
mechanics.
Monitor the side frames during unfolding or folding and fold them smoothly until the end position.
3.5.1
Unfolding the Machine
1.
Release the catches of the side frames so that the exclamation mark is covered, which means that the frames
are released, see Picture
10
/p.16, and open the ball valve of the side frames, Picture
19
/p.17.
