Manual
EXCELENT Premium 6; 8
12
│
52
3.
PUTTING INTO OPERATION
Before you take over the machine, test and check it for any damages incurred during transportation and
check that all parts included in the delivery note have been delivered.
Before you put the machine into operation, read the instructions for use carefully, particularly chapters
A-
E
p.5-10. Learn about the control elements of the machine and its overall function before the first use.
When working with the machine, observe the instructions in the manual as well as generally valid rules for
the safety at work, protection of health, fire and traffic safety and protection of environment.
The operator must check the machine before every use (putting into operation) for aspects in the field
of completeness, safety at work, work hygiene, fire safety, traffic safety and protection of environment.
If the machine shows signs of damage, it must not be put into operation.
Execute aggregation of the machine with the tractor on an even and compact surface.
When working on slopes, observe the lowest slope accessibility of the whole set
TRACTOR –
MACHINE.
Before turning on the engine of the tractor, check that there are no people or animals in the working area
of the set and press the warning sound signal.
The operator is responsible for safety and for all damages caused by the operation of the tractor and the
attached machine.
The operator must observe technical and safety regulations of the machine determined by the producer
when working with the machine.
The operator must raise the machine when turning at the plough turning end, i.e. the working parts must
not be in the ground.
The operator must observe the prescribed working depths and speeds set in the instructions for use in Tab.
10
/p.38 and
11
/p.39 when working with the machine.
The operator must lower the machine to the ground and secure the set against movement before leaving
the cabin of the tractor.
3.1.
AGGREGATION TO THE TRACTOR
The machine may only be connected to a tractor whose standby weight equals or is higher than the total
weight of the attached machine.
The operator must observe all generally valid regulations for the safety at work, protection of health, fire
safety and protection of environment.
The operator may only attach the machine to a tractor which is equipped with a rear three-point mounting
(TPM) and a functional undamaged hydraulic system.
The table with the requirements for the tractive instrument for work with the machine:
Tab.4
(5)
Requirement for the engine power of the tractor for
EXCELENT Premium 6
147 kW*
(5)
Requirement for the engine power of the tractor for
EXCELENT Premium 8
176 kW*
(6)
Requirement for TPM of the tractor
(7)
distance of the bottom suspension
hinges (at the axes of the hinges)
1010±1,5 mm,
(can be also set to 910±1,5
mm)
(8)
holes of the bottom suspension
joints for the suspension hinge pins of
the machine
37,5 mm
(9)
Requirement for the hydraulic system of the
tractor
(x)
circuit of the electric distributor
(14)
Pressure in the circuit
min.190 bar – max.230
60 l/min., 2 sockets for
snap coupling ISO 12.5
(19)
circuit of the hydraulic engine
(20)
Pressure in the filling
branch min.130 bar–
max.230 bar, 1 socket for
snap coupling ISO 12.5
(21)
Pressure in the waste
branch max.3 bar, 1
socket for snap coupling
ISO 20
