Farm King 12112, Operator And Parts Manual

Page: 59 / 158

Assembly - Backsaver Auger 12112 / 12122
59
Figure 89
Thread the 3/8” cable through the upper pulley (Item 1)
and around the lower pulley (Item 2)
[Figure 89] . Route
the cable to the hopper winch.
Figure 90
Install the cable clamp (Item 1) [Figure 90] using the two
bolts provided with winch. Leave bolts loose.
Route the cable over the top of the hand winch drum.
Install the cable (Item 2) from the inside of the drum
through one of the dimpled holes (Item 3)
[Figure 90] in
the outer plate.
Loop the cable around the drum bearing. Feed the cable
between the loop and outer plate, then through the cable
clamp.
Leave approximately 1” of cable extending past the
clamp. Tighten and torque the clamp bolts to
approximately 2 ft.-lb. (3 N•m).
Turn handle to wrap cable around drum.
Figure 91
Attach the hopper winch cable to the bracket (Item 1) on
the right side of the drive section. Using the handle (Item
2)
[Figure 91] , wind the cable onto the drum of the
winch.
NOTE: This is for storing cable until hopper is
installed.
CUT HAZARD
To prevent injury to fingers and hands:
• Always wear heavy leather gloves when handling
a wire rope.
• Never let wire rope slip through your hands.
B-4082
1
2
Do not remove the drum to install the cable.
B-0582
2
1
3
B-3042
2
B-3041
1