Farm King 12112, Operator And Parts Manual

Page: 25 / 158

Safety - Backsaver Auger 12112 / 12122
25
SAFETY SIGNS (DECALS) (CONT’D)
Lower Tube
WARNING
AN OPERATOR’S MANUAL IS FURNISHED WITH EACH GRAIN AUGER.
ADDITIONAL OR REPLACEMENT MANUALS ARE AVAILABLE.
DO NOT OPERATE THE UNIT BEFORE READING AND UNDERSTANDING THE OPERATOR’S
MANUAL.
UNDERSTAND THE OPERATING PROCEDURES BELOW TO AVOID PERSONAL INJURY OR
DEATH.
KEEP ALL SAFETY DEVICES IN PLACE! DO NOT ADJUST, SERVICE, LUBRICATE, CLEAN, UNCLOG OR
MOVE THE MECHANISM UNTIL ALL POWER IS SHUT OFF! KEEP HANDS, FEET AND CLOTHING AWAY
FROM MOVING PARTS WHILE IN OPERATION! KEEP OFF THE EQUIPMENT AT ALL TIMES! MAKE
CERTAIN THAT EVERYONE IS CLEAR OF THE EQUIPMENT BEFORE APPLYING POWER! KEEP CHILDREN,
VISITORS AND ALL UNTRAINED PERSONNEL AWAY FROM MACHINE WHILE IN OPERATION!
Intentional or accidental contact with moving parts may result in a SERIOUS INJURY OR DEATH. Observe the
following operating procedures:
NEVER MOVE THE AUGER MANUALLY! BE SURE AUGER IS EMPTY BEFORE ATTEMPTING TO MOVE!
NEVER PUSH ON THE UNDERCARRIAGE OF THE AUGER! TOW THE AUGER AT SLOW SPEED AND IN
THE DOWN POSITION! ALWAYS TEST THE INTAKE END OF THE AUGER FOR DOWNWARD WEIGHT WHEN
ATTACHING OR RELEASING!
NEVER RAISE THE HITCHPOINT HIGHER THAN THE VEHICLE’S TOW BAR.
Care must be used when moving or transporting the auger. Accidental tipping or upending of an auger can
occur and may cause SERIOUS INJURY OR DEATH to the operator or bystanders.
WHILE UNIT IS IN OPERATION! WHEN DISMOUNTING THE UNDERCARRIAGE!
WHILE UNIT IS IN OPERATION! WHEN MOVING THE AUGER! WHEN RAISING OR LOWERING THE
AUGER!
Maximum elevation is determined by interference between track car and auger structure. The operator
MUST STOP RAISING the auger BEFORE track car reaches the end of the track. Continued lift will cause
failure of the winch, lift cable or auger supports, causing auger to collapse, resulting in SERIOUS INJURY
OR DEATH!
An auger can collapse and fall on the operator or bystanders causing a SERIOUS INJURY OR DEATH. Always
support the discharge end when the following conditions occur:
The accidental tipping or upending of an auger may cause SERIOUS INJURY OR DEATH to the operator or
bystanders. When the grain flow is shut off to the auger an overbalance situation can occur, suddenly
raising the intake of the auger. Adequate anchorage of the intake end or support from the bin is required at
all times, especially in the following conditions:
Contact with overhead wires may cause ELECTROCUTION of the operator or bystanders. Contact with overhead
obstructions can cause collapse or tipping of the auger or may cause the overhead obstruction to fall. In both
cases the operator or bystander can be SERIOUSLY INJURED OR KILLED! Observe the following: TOW THE
AUGER AT SLOW SPEED AND IN THE DOWN POSITION! RAISE OR LOWER THE AUGER SLOWLY!
Electrical malfunction can cause ELECTROCUTION of the operator or bystanders. Observe the following rules:
DISCONNECT POWER AND ELECTRICAL DRIVEN UNITS BEFORE RESETTING MOTOR OVERLOADS!
DO NOT OPERATE ELECTRIC MOTOR EQUIPPED UNITS UNTIL UNIT IS PROPERLY GROUNDED!
Contact with rotating flighting will cause SERIOUS INJURY OR DEATH! DO NOT STAND ON INTAKE CAGE!
KEEP HANDS, FEET AND CLOTHING AWAY FROM THE INTAKE AND DISCHARGE FLIGHTING!
06010
B-3131
1
p/n SZ06010
1