Farm King 12112, Operator And Parts Manual

Page: 45 / 158

Assembly - Backsaver Auger 12112 / 12122
45
Raise the lower truss tube weldment (intake end) to lower
the discharge tube weldment to the desired assembly
height.
Figure 44
Align the top truss tube weldment mounts (Item 1) with
the discharge tube weldment mount (Item 2)
[Figure 44]
(both sides).
Figure 45
Install two 1/2” x 1-1/2” bolts (Item 1) [Figure 45] through
the tube adjustment bracket (Item 2), slotted hole of the
top truss tube weldment and discharge tube weldment
mount. Install one 1/2” flat washer and 1/2” lock nut onto
the bolts (both sides).
Figure 46
Locate two 1/2” x 6-1/2” threaded rods (Item 1). Thread
two 1/2” nuts (Item 2)
[Figure 46] approximately half way
onto each threaded rod.
Install the threaded rods through the two tube adjustment
brackets (both sides). Install one 1/2” nut (Item 3)
[Figure
46] onto each end of the threaded rod.
Figure 47
Sight down the top of the discharge tube weldment (from
the discharge end) to verify that the discharge tube
weldment is in line with the top truss tube weldment
[Figure 47] .
B-3061A
2
1
B-3012A
1
2
B-3013A
2
1
3
3
B-1170
OFFSET TO THE LEFT SIDE
OFFSET TO THE RIGHT SIDE
TUBES ALIGNED