11
⑪
In case of oil (grease) leakage, clean it up immediately and seal well the place where
leakage occurs. Oil or grease leakage on the floor will easily bring about hazards to the
operators.
⑫
During operation, the machine must be equipped with safety devices, which may be
neither removed and abandoned nor reduced in functions. Otherwise,
FAMSUN
is not
responsible for any accidents resulted wherefrom and reserves the right to ascertain
where the responsibility lies.
1.8 Explosion Protection: Precautions against Dust Explosion and Fire Hazard
(1) General housekeeping
①
Keeping the work place with combustible dust free is an important condition for safe production.
②
Ensure not to pile bagged or bulk materials between machines.
③
In order to reduce dust emission to surrounding areas, keep all conveying devices, air pipes, filter
bags in good condition without any leakage especially pipes and covers of the conveying devices.
④
In order to reduce dust explosion hazard, dusts must be cleaned out frequently and effectively
everywhere.
⑤
Keep all motors free of deposited dusts.
(2)Regular inspection and maintenance
①
Check the safety devices such as speed monitor or the like apparatus regularly, at least once a
week.
②
Check and clean the magnetic separator regularly, at least once a day.
③
In order to avoid heat generation, it is necessary to regularly check the functions of all main shafts
and bearings, at least once a week, and to fill up with lubricant on regular basis..
(3)Electric apparatus
Regularly check the electric apparatus and articles with special care for the following:
①
Do not use any flashlights and other lamps without shielding or explosion-proof glass.
②
Do not use any cable extension or electric heater.
③
Repair or replace the electric apparatus and equipment immediately if any failure
occurs.
④
Do not install the cables directly on the floor.
⑤
Cut off the power supply of the machine after work.
⑥
Assign an electrician to check the insulation of all the power lines of electric network
according to relevant regulations, at least once a year.
(4)Smoking and welding
①
No smoking. Such stipulation is applicable to all workers and staff of the enterprise as
well as guests, customers, outcomers and drivers visiting the factory.
②
If the tools such as welding machine or soldering lamp (flame soldering lamp) etc. are