10
(3)In order to ensure safety and health for the workers during production process, it is
required to use personal protection equipment (such as gloves, breathing masks and
safety shoes) during operation.
(4) Please execute the special regulations on accident prevention in the operation manual
provided by
FAMSUN
.
(5) The enterprises are obligated to execute following regulations to ensure operators'
safety.
①
The coupling guards must be mounted at any time and kept in place. It is very
dangerous when they are opened or dismantled to cause casualty accident. This is also
applicable to the preventive device of the robot.
②
Keep the safety limit switches in good order. Do not bypass or discard the safety limit
switches.
③
The drive motor must be switched off to absolutely stop the machine prior to inspection,
commissioning, repair and maintenance. This can be done through a full-phase cut-off
and lockable switch which is installed near the machine or on the operation desk or the
control panel on site. It is improper only to screw off the fuse wire!
④
If the machine needs other energy like pneumatic, hydraulic, steam and hot water
energy, cut off the energy supply or turn off the switch and to release the pressure in the
internal pipeline system of the machine.
⑤
As for handling heated or cooled parts and components of the machine, watch for the
danger of burning or scalding, frost-bitting.
⑥
If you have pressed the emergency-stop switch to shut down the machine and you want
to reset the switch, it is not permissible to only re-press this button rather to turn on the
main switch to restart the machine.
⑦
If some machines are equipped with a partial shutdown system, a special care should
be taken. Read the instruction manuals provided for the machine carefully. In such
machines with a partial shutdown system, temperature will rise because pressure or
vacuum will build up after they have been used for a while.
⑧
Cleaning, lubricating and oiling of the machine or its parts and components may be
allowed only when the machine is not in running. If you have to climb on or enter the
machine to do such work, follow the rules positively without exception: surely cut the
power supply of motors and lock the switch with a warning tag attached. Meanwhile
climbing should comply with the related safety regulations.
⑨
Be careful: never do sampling from inside of the machine unless there is not any danger.
Usually, take the samples from the pipe under the machine instead of inside of machine.
⑩
Clean out the deposited dust, dirt and materials frequently. Keeping the machine clean
can enhance production safety and housekeeping level of workshop, and is also
beneficial to prevent dust explosion.