40
ENGLISH
Functions for kits with song:
TIME:
Shows you the played time of the song. If no song is selected, "-" appears in the display. (The
knob has no function).
PITCH
: This function allows you to change the tempo of the song. A range between .50 and 1 is
available. This function is useful for slowing down the song when practicing. Please note that this also
changes the pitch.
Functions for Kits with Metronome:
BAR:
Shows the selected metronome setting. While the metronome is running, you can read the
current bar and count time here. (The knob has no function)
TEMPO:
Here you can read and set the current tempo of the metronome. A tempo range from 30 to
280 bpm is available. If you press the knob while holding down the MORE button, a right arrow
appears and you can set the tempo in decimal steps. If you press the knob again while holding down
the MORE button, you can change the tempo again in whole bpm steps.
The tempo of the metronome is saved in the selected kit. If you want to change and save the tempo,
you must save the kit (SAVE). This function is also useful for preparing different tempos for a live
performance, which you can then recall one after the other by selecting the corresponding kits.
STOP ALL:
The button combination MORE + STOP (middle DATA button) stops the output of all
sources at once (song, metronome, loops).
9.2 EQ
A 3-band equalizer with semi-parametric mid-band is available per kit
CURVE:
Shows you a graphical representation of the equalizer settings that have been made. Press
the left DATA button (via CURVE) to reset the EQ. Press the button again to restore the deleted
setting.
FREQ:
Use the DATA button to select the desired frequency for the centre band. Frequencies from
125 Hz to 8 kHz in octave steps are available. You can also set the desired frequency with the knob.
To do this, press the knob while holding down the MORE button. The display changes to MID
↑
. You
can now adjust the corner frequency of the mid-band even more finely, in one-third octave steps from
100 Hz to 10 kHz.
BUS:
Select the signal to which the EQ is to be applied. Available for selection:
Drum:
The drum channels are individually routed through the EQ. Turn on the EQ on the VOL
page separately for each channel you want.